Ideally the Dimensions of an Undermount Rangehood Cabinet should be 76mm deeper and 100mm wider than the specified cut out size. For example if the Rangehood cut out was 260mm deep x 500mm wide the cabinet should be at least 336mm deep and 600mm wide. This will leave 30mm from the Rangehood Cut out to the gables, back and to the front of the carcass allowing for the bottom to be screwed with 45mm screws and keep its structural integrity.
If this Cabinet is to be Finger Pull then you should allow another 20mm in overall depth to the cabinet.
To choose what parts you require in your Undermount Rangehood Click on the Kits Menu Bar and select Included Kits (See Below for explanations). In most cases a Fixed Shelf, a Rangehood Duct-Fixed, a Cover Panel and an Undermount Cut out are ordered.
Remember to delete the Adjustable shelves or if they are required they will need to be ordered as Adjustable shelf - Variable width as they will be sitting between the fixed duct and the gables. (see extra cabinet parts for more info on ordering shelves)
- Rangehood Fixed Shelf is supplied loose to be fitted on site.
- Rangehood Duct is ducting built to suit the duct requirements of your hood. It is supplied over sized in height by standard.
- Rangehood Cover Panel is a panel supplied to cover the front of the hood. It is supplied over sized in height by standard.
- Fixed Shelf is supplied fitted to the cabinet.
- Undermount Cut Out Required is selected when you want the bottom to be routed to suit an undermount rangehood.
- Bottom Scribe is used to specify a height that the carcass is raised behind the doors. Generally used when hiding an underpanel behind the doors.